Guitars101 - Guitar Forums banner

1 - 4 of 4 Posts
G

·
Discussion Starter #1
Hi All

I'v given my brother a 96 US stratocaster (pretty beaten up but its stil a fender)
I need the measurements for the back plate out line and hole layout.
I want to make a special one for him, (They'w got a laser cutter at work) with his name on it and so on.

Thanks in advance

Claus Hollen Nielsen

Denmark
 

·
Registered
Joined
·
733 Posts
hmm...if you want to be precise machining it out, i would just go to a music shop and get a cheap plastic one. just check and see if it fits the bolt pattern, then cut it out.
 

·
Banned
Joined
·
7,011 Posts
I want to just tell you they are standard size and about $5 from your local guitar store, but I can get you exact measurements from one of mine if you want. I havwe a dinner party about to start, so I can do it when everyone gets the hell out of my home! ;)
 
G

·
Discussion Starter #4 (Edited)
Thanks El_jalepeno

That would be great.
Best If you could measure it in millimeters, im not use to inches. :icon_redf
Went a lot better than i expected.
But people are very help full on the web.

Claus Hollen Nielsen

Hey and a merry x-mas to every body :santa:
 
1 - 4 of 4 Posts
Top