Guitars101 - Guitar Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
733 Posts
on a 4 conductor duncan the black is your main hot wire, the red and white are soldered together on the switch, and the green and bare are soldered to ground.
looking at the diagram i think the black would go where the white is coming of the small switch to the bridge pickup. green and bare are grounded, then just tie red and white together..dont solder them to anything just together.
that should be able to hot the pickup. ive never wire a jaguar before, so not entirely sure...
but make sure you tie the red and white together, because thats what completes the circuit from one coil of the pickup to the other.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top